Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 5 Next »

Released versions:

This release note applies to the following models:

Version 2.28 or later

WV-S85702-F3L

WV-S85402-V2L

WV-S85702-F3L1

WV-S85402-V2L1

Priority Rank Level

🇦 : Recommended to apply
🇧 : When issue happened
🇨 : Maintenance timing
🇺 : Function / performance improvement

Version 2.40

Release date: Sept 28, 2023 - Download the latest firmware

New Features / Improvements

  • Improved the performance while updating or installing extension software to avoid failure in a slow network. 🇺

  • Enabled [Guest User] by default on the [User auth.] tab in [User mng.] 🇺

  • Improved the response to the following CGI commands. 🇺

    • /cgi-bin/getdata

    • /cgi-bin/get_capability

  • Improved the ONVIF connection. 🇺

  • Improved the data management when updating extension software applications. 🇺

  • Improved the SRTP communication. 🇺

  • Changed the [SNMP] default setting to Off on the [Network] page. 🇺

  • Improved the performance while downloading a video data from an SD memory card in an unstable network. 🇺

Resolved Issues

  • Corrected an issue where an mp4 video recorded on an SD memory card could not be played back on the camera. 🇨
    Occurrence condition: Record an mp4 video with [GOP control] set to "Advanced(Fixed GOP 60s w/1s key-frame)"

  • Corrected an issue where a communication error might occur on the connected i-PRO recorder on rare occasion. 🇨
    Occurrence condition: Start sequence display on the recorder while performing SD memory card recording on the camera.

  • Corrected an issue where the angle of view shifted after restarting the camera. 🇨
    Occurrence condition: Use digital zoom in to set the angle of view.

  • Corrected an issue where the [Save trigger] setting of SD memory recording might unexpectedly changed after firmware update. 🇨

  • Corrected an issue where an unnecessary pop-up regarding the bit rate of recording stream appeared. 🇨

  • Corrected an issue where the port of [Destination of Trap] was always the default value (162) in the actual operation, even when any other port number is set on the SNMP trap setting. 🇨

  • Corrected an issue where MQTT notification worked only when [AI analytics target] is set to "Other" for audio detection. 🇨

  • Removed an unnecessary alarm icon shown on setting windows. 🇨

Version 2.28

Release date: April 4, 2023

  • First mass-production

  • No labels