Released versions:

...

• Corrected an issue where the image might gradually get out of focus in version 2.60. 🇨
  Occurrence conditions:
  After auto focus/preset sequence while the frame rate is limited to 15fps(12.5fps*) under the following setting.

  • Extension software is working

  • [Super Dynamic] level is set to 30 or higher

  • [Privacy Mask] is enabled

  • [Stabilizer] is enabled

  • [Maximum shutter] is set to 2/30s(2/25s*) or longer

*When 25fps is selected for [Image capture mode].

• Corrected the sensitivity of [VMD information addition] on the preset position. 🇨
  

  Anchor
  V2.60 V2.60

...

Release date: Sept 28, 2023
->Updated on Oct 31: Added an item written in red

New Features / Improvements

...

• Corrected an issue where the camera showed a blank pop-up of installation status error. 🇨

• Corrected an issue where the image could not be zoomed out on video management system. 🇨
  Occurrence condition: After maximum zoom by mouse drag. 🇨

• Corrected an issue where the camera rebooted. 🇧
  Occurrence conditions:
  - [Image capture mode] is "4:3 mode(30fps mode)" or "4:3 mode(25fps mode)"
  - Digital zoom to the maximum level

• Corrected an issue where an mp4 video recorded on an SD memory card could not be played back on the camera. 🇨
  Occurrence condition: Record an mp4 video with [GOP control] set to "Advanced(Fixed GOP 60s w/1s key-frame)"

• Corrected an issue where a communication error might occur on the connected i-PRO recorder on rare occasion. 🇨
  Occurrence condition: Start sequence display on the recorder while performing SD memory card recording on the camera.

• Corrected an issue where the [Save trigger] setting of SD memory recording might unexpectedly changed after firmware update. 🇨

• Corrected an issue where the camera showed low image quality. 🇨
  Occurrence conditions:
  - [Stabilizer] is On in the [Basic] setting
  - [Frame rate] is set to 8.3fps, 4.2fps or 3.1fps

• Corrected an issue where the port of [Destination of Trap] was always the default value (162) in the actual operation, even when any other port number is set on the SNMP trap setting. 🇨

• Corrected an issue where MQTT notification worked only when [AI analytics target] is set to "Other" for audio detection. 🇨

• Corrected an issue where [Auto track] and [Auto track alarm setting] were disabled when [Maximum shutter] is set to "Max.2/30s" or longer value. 🇨

• Corrected an issue where the window to set preset positions did not appear when setting VIQS. 🇨

• Corrected an issue where multi-screen live view might not show images from other cameras. 🇨
  

  Anchor
  V2.36 V2.36

Version 2.36

...