Table of contents
...
Table of Contents | ||||
---|---|---|---|---|
|
Introduction
...
You can output a debug log from AdamApp by using ADAM_DEBUG_PRINT() fuction included in AdamDebug.h. (In this case, you do not need to call ADAM_DEBUG_OPEN() function nor ADAM_DEBUG_CLOSE() function.)
...
Also, this tutorial refers to the SDK installation directory as ${SDK_DIR}.
How to view debug logs on i-PRO
...
(1) Launch Google Chrome
(2) Click the "Extensions" button on the right side of the address bar in Chrome and click "Adam application manager for i-pro".
...
Note |
---|
However, you cannot connect to the camera unless you are logged in to the camera. |
Enable UDPLog
Set IP address and port number of PC to receive UDPLog by using Adam Control Extension.
Info |
---|
Check the PC's IP address by using ipconfig at the command prompt. |
...
Receive UDPLog
The tools for receiving and displaying UDPLog consists of ‘UDPLog receiving server’ and ‘UDPLog Receiver (Google Chrome extension)’. They are included in the iPRO_CAMERA_SDK as shown below.
...
${SDK_DIR}/tool/ResourceMonitorExtension
* ‘UDPLog Receiver’ is included in ‘Resource Monitor’.
...
UDPLog receiving server
Start UDP Log receiving server by disabling the firewall on your PC(If you do not disable the firewall, please set the port appropriately or configure the security software appropriately).
...
Here, leave the default values and click the START button to start the UDPLog receiving server.
UDPLog Receiver
Launch Resource Monitor. Please refer to here(how to install) and here(how to launch) for how to install Resource Monitor and how to launch Resource Monitor respectively. Select ‘UDPLog Receiver’ in ‘Select Mode’.
...